Headlight assy.
- Remove the screw shown in the figure and re-
move the grill, pulling it upward and then out.
Removing the ignition key-switch when on *off*
- Remove central cover .
- Insert a small centre-punch through the hole
shown by the arrow in the figure and push until the
retaining tooth on the master cylinder is released:
whilst keep the punch pressed against the tooth,
extract the lock body and master cylinder.
See also
Legshield
Removing the ignition key-switch when on *lock*
Remove the shield.
- Remove the switch of the key switch.
- Make a hole on the block using a drill as shown
in the figure.
- Insert the wheel cylinder with the key and with the
anchoring tab facing down halfway on the lock
body taking care that the insertion phase of the key
is oriented matching "ON" (the only position that
enables the cylinder to get into the lock body); now
turn the key leftwards to "OFF" and at the same
time press until the cylinder is completely in.
See also
Chassis Runner Purejet
CHAS - 4
To Next Page