COMING INTO CONTACT WITH EYES OR SKIN, WASH ABUNDANTLY WITH WATER FOR AP-
PROX. 15 MIN. AND SEEK IMMEDIATE MEDICAL ATTENTION.
IN THE EVENT OF ACCIDENTAL INGESTION OF THE LIQUID, IMMEDIATELY DRINK LARGE
QUANTITIES OF WATER OR MILK, MAGNESIUM MILK, BATTERED EGG OR VEGETABLE OIL.
SEEK IMMEDIATE MEDICAL ATTENTION.
THE BATTERIES PRODUCE EXPLOSIVE GAS; KEEP CLEAR OF NAKED FLAMES, SPARKS OR
CIGARETTES; VENTILATE THE AREA WHEN RECHARGING INDOORS.
ALWAYS WEAR EYE PROTECTION WHEN WORKING IN THE PROXIMITY OF BATTERIES.
KEEP OUT OF REACH OF CHILDREN
Characteristic
Battery
12V-9Ah
Commissioning dry-charge batteries:
1) Once the short closed tube and caps are removed, add sulphuric acid to the elements, of a type for
batteries with a specific gravity of 1.26, corresponding to 30° Bé at a temperature of at least 15°C until
reaching the upper level.
2) Let it sit for two hours.
3) Use the specific battery charger (single or multiple) to charge to an intensity equal to around 1/10 of
the capacity until the voltage has reached a value of around 2.7 V per element. The density of the acid
should be about 1.27, corresponding to 31° Bé, and the values have stabilised. The duration of the
charging operations must be 15 - 20 hours.
4) Once the charging is complete, level out the acid (add distilled water or remove excess acid), put
on the caps and clean carefully.
5) Once these operations have been completed, install the battery on the vehicle, correctly following
the connections described in point 3) «Battery charging».
WARNING
- ONCE THE BATTERY HAS BEEN INSTALLED IN THE VEHICLE IT IS NECESSARY TO REPLACE
THE SHORT TUBE (WITH CLOSED END) NEAR THE + POSITIVE TERMINAL WITH THE CORRE-
SPONDING LONG TUBE (WITH OPEN END), THAT YOU FIND FITTED TO THE VEHICLE, TO
ENSURE THAT THE GASES THAT FORM CAN ESCAPE PROPERLY.
Specific tooling
020333Y Single battery charger
020334Y Multiple battery charger
Battery maintenance
The battery is the electric device that requires the
most careful monitoring and diligent maintenance.
The maintenance rules are:
1) Check the level of the electrolyte
Check regularly that the electrolyte level is at up-
per level. Use only distilled water to top up the
level.
Electrical system Runner Purejet
ELE SYS - 14
To Next Page