External Ports: The numbers of external ports. You can enter a specific port
number or a range of service ports (E.g 100-300).
Internal Ports: The internal port number of the device. You can enter a specific
port number. Leave it blank if it is same as the external port.
Protocol: The protocol used, you can choose TCP, UDP, or both TCP and UDP.
Status: Activate of Deactivate the rule.
6.2. Open Ports on Router
The router's services, such as web, FTP and so on, require their respective ports
to be opened on the router in order to be publicly reachable.
To open a port, click Open Ports on Router and input the required parameters or
click Add a New One.
Name: The name of the rule which can be specified by the user.
Port: The port number that you want to open.
Protocol: The protocol used, you can choose TCP, UDP, or both TCP and UDP.
Status: Activate of Deactivate the rule.
6.3. DMZ
DMZ allows you to expose one computer to the Internet, so that all the inbounds
packets will be redirected to the computer you set.
Click DMZ and enable Open DMZ. Input the internal IP address (E.g.
192.168.8.100) of your device which is going to receive all the inbound packets.
To Next Page
Loading...
Need help?
General
