GL-INET Opal User Manual

Page 146 | 153
10.8 Extensible Authentication Protocol (EAP)
Introduction
You can connect to EAP (Extensible Authentication Protocol) Wi-Fi network
which requires username and password authentication on GL.iNet routers.
This guide is how to connect an EAP Wi-Fi network via GL admin panel.
• Supported models: GL-AR300M Series, GL-USB150, GL-AR750, GL-
AR750S, GL-B1300, GL-S1300, GL-AP1300, GL-E750, GL-X750, GL-MiFi,
GL-XE300, GL-AX1800, GL-B2200, GL-X300B, GL-X1200, GL-AXT1800
• Not supported models: GL-MT300N-V2, microuter-N300, GL-MT1300,
GL-MV1000W, GL-MV1000, GL-SF1200, GL-SFT1200

GL-INET Opal Specifications

General

RAM	128 MB DDR2
WiFi	802.11b/g/n
USB Port	1 x USB 2.0
VPN Support	OpenVPN, WireGuard
Operating System	OpenWrt
Processor	QCA9531, 650MHz
Flash Storage	16 MB
Ethernet Ports	2 x 10/100 Mbps
Power Input	5V/2A