Need help?Do you have a question about the GL-INET Opal and is the answer not in the manual?
General| RAM | 128 MB DDR2 |
|---|---|
| WiFi | 802.11b/g/n |
| USB Port | 1 x USB 2.0 |
| VPN Support | OpenVPN, WireGuard |
| Operating System | OpenWrt |
| Processor | QCA9531, 650MHz |
| Flash Storage | 16 MB |
| Ethernet Ports | 2 x 10/100 Mbps |
| Power Input | 5V/2A |
Navigate to the router's IP address via a browser to configure settings and check status.
Connect the router to a modem or main router via Ethernet cable for internet access.
Connect to the internet using a USB 3G/4G modem by inserting a SIM card.
Allow remote access to specific services or computers within the local network.
Configure router to make specific services publicly reachable by opening necessary ports.
Set up an OpenVPN connection using configuration files provided by a VPN service.
Configure the router to act as an OpenVPN server for secure remote access.
Configure a WireGuard VPN connection using provided configuration details.
Set up the router as a WireGuard server for secure peer-to-peer connections.
Define routing rules to direct specific traffic through VPN or bypass it.
Map a domain name to the router's dynamic IP address for remote access.
Reset the router to its original factory settings, erasing all configurations.
Restore network functionality or factory defaults using the reset button.
Recover a 'bricked' router by re-installing firmware using the Uboot interface.
To Next Page
