• For GL-MT1300, the LED is blue at first, flash twice
slowly, then light 5 times a bit quick and turn to white
and stay on.
• For GL-SFT1200(Opal), the blue LED flashes 5 times
then turns white and stay on.
• For GL-B2200, the two LEDs are blue at first, then turn
white to flash 5 times, then turn blue and stay on.
• No repeat LED flashes signal for GL-MV1000.
(Power and WAN LEDs will stay on the whole time.)
5. Set your computer’s IP address to 192.168.1.2. Please check the step-by-
step guide for different operating systems below:
Windows 7 / Windows 10
a. Go to Control Panel -> Network and Internet -> Network and Sharing Center ->
Change adapter settings.
b. Right click Local Area Connection -> Properties.
c. Click Internet Protocol Version 4 (TCP/IPv4) -> Properties.
d. Set the IP adress to 192.168.1.2 manually.
To Next Page
Loading...
