Need help?Do you have a question about the Global JUNIOR V4 and is the answer not in the manual?
General| Brand | Global |
|---|---|
| Model | JUNIOR V4 |
| Category | Control Panel |
| Language | English |
Covers the manual's introduction, panel key features, access levels 1 and 2, and user/installer codes.
Details the typical system schematic, component identification, and ABS box information.
Explains power requirements, battery calculations, EN54 compliance, recommended cables, limitations, and definitions.
Covers initial panel setup, mains power connection, other connections, and repeater installation.
Details fitting the Junior Expansion Loop Card and data loop topologies.
Provides instructions for RS485, Fiber-Optic, and TCP/IP connections for panels and repeaters.
Explains conventional sounder circuits, auxiliary relays, fault relay, and panel battery connections.
Covers commissioning introduction, panel button functions, and initial panel/repeater startup.
Details entering programming mode, logging in, system checks, and learning installed devices.
Explains loop monitoring, sounder tests, detector tests, and wrapping up installation.
Describes procedures for testing battery fault messages and power failure response.
Introduces programming functions, keys, and general usage guidelines.
Covers functions for disabling and assigning zones, sounders, and input/output groups.
Details device setup, including general settings, heat/smoke sensitivity, and Discovery protocol.
Explains ASET mode, troubleshooting SAMs, device monitoring, and time/date settings.
Covers special features, memory management, PC linking, and access code settings.
To Next Page