GMG 1930ED - Page 25

Page 25 of 52
5.2.A TEST FUNCTION ENABLE AND UP/DOWN FUNCTIONS
Check the area above and around the machine for obstructions and electrical
power lines before operating the machine.
Operating Instructions & Function Tests
20. Toggle this switch to the UP position for Lift function.
21. Slowly move the CONTROL HANDLE forward and following reverse - not holding the Enable
switch on the control handle.
No functions should operate.
22. Press and hold the FUNCTION ENABLE SWITCH on the control handle.
23. Slowly move the CONTROL HANDLE reverse.
The platform should raise. Releasing the control handle should stop the function.
24. Press and hold the FUNCTION ENABLE SWITCH. Slowly push the control handle forward.
The platform should lower. The descent alarm should sound while the platform is lowering.
Control handle forward Control handle reverse
5.2.B TEST FUNCTION ENABLE AND UP/DOWN FUNCTIONS
20. Activate the Lift functions by pressing the LIFT-FUNCTION BUTTON.
One pressed - the LED centred in this button will lit up.
21. Slowly move the CONTROL HANDLE forward and following reverse - not holding the Enable
switch on the control handle.
No functions should operate.
22. Press and hold the FUNCTION ENABLE SWITCH on the control handle.
23. Slowly move the CONTROL HANDLE reverse.
The platform should raise. Releasing the control handle should stop the function.
24. Press and hold the FUNCTION ENABLE SWITCH. Slowly push the control handle forward.
The platform should lower. The descent alarm should sound while the platform is lowering.
5.2.C TEST FUNCTION ENABLE AND UP/DOWN FUNCTIONS
20. Activate the Lift functions by pressing the LIFT-FUNCTION BUTTON.
One pressed - the LED in this button will lit up.
21. Slowly move the CONTROL HANDLE forward and following reverse - not holding the Enable
switch on the control handle.
No functions should operate.
22. Press and hold the FUNCTION ENABLE SWITCH on the control handle.
23. Slowly move the CONTROL HANDLE reverse.
The platform should raise. Releasing the control handle should stop the function.
24. Press and hold the FUNCTION ENABLE SWITCH. Slowly push the control handle forward.
The platform should lower. The descent alarm should sound while the platform is lowering.