GMG 1930ED - Page 27

Page 27 of 52
5.5.A TEST LIMITED DRIVE SPEED
33. Toggle this switch to the UP position for Lift function.
34. Press the FUNCTION ENABLE SWITCH. Raise the platform approximately 2 m from the
ground.
35. Toggle this switch to the DOWN position for Drive function.
36. Press and hold the FUNCTION ENABLE SWITCH on the control handle.
37. Slowly move the CONTROL HANDLE to the full drive position.
The maximum achievable drive speed with the platform raised should not exceed 30.5 cm/s.
• If the drive speed with the platform raised exceeds 30.5 cm/s, immediately tag and remove
the machine from service.
5.5.B TEST LIMITED DRIVE SPEED
33. Activate the Lift functions by pressing the LIFT-FUNCTION BUTTON.
34. Press the FUNCTION ENABLE SWITCH. Raise the platform approximately 2 m from the
ground.
35. Activate the Drive functions by pressing the DRIVE-FUNCTION BUTTON.
36. Press and hold the FUNCTION ENABLE SWITCH on the control handle.
37. Slowly move the CONTROL HANDLE to the full drive position.
The maximum achievable drive speed with the platform raised should not exceed 30.5 cm/s.
• If the drive speed with the platform raised exceeds 30.5 cm/s, immediately tag and remove
the machine from service.
5.5.C TEST LIMITED DRIVE SPEED
33. Activate the Lift functions by pressing the LIFT-FUNCTION BUTTON.
34. Press the FUNCTION ENABLE SWITCH. Raise the platform approximately 2 m from the
ground.
35. Activate the Drive functions by pressing the DRIVE-FUNCTION BUTTON.
36. Press and hold the FUNCTION ENABLE SWITCH on the control handle.
37. Slowly move the CONTROL HANDLE to the full drive position.
The maximum achievable drive speed with the platform raised should not exceed 30.5 cm/s.
• If the drive speed with the platform raised exceeds 30.5 cm/s, immediately tag and remove
the machine from service.
Operating Instructions & Function Tests