GMG 1930ED - 4646ED
Operator’s manual
Operator’s Manual - 1930----4646ED
March 2019 #940400-3-EN
6.3 OPERATION FROM LOWER CONTROLS
Drive and steer functions are not available from the LOWER CONTROLS.
6.4 OPERATION FROM PLATFORM CONTROLS
6.4.1.A TO POSITION PLATFORM
Check the area above and around the machine for obstructions and electrical
power lines before operating the machine.
Check the area above and around the machine for obstructions and electrical
power lines before operating the machine.
1. Turn the KEY SWITCH to LOWER CONTROLS.
2. Set the EMERGENCY STOP to the ON position at both the lower and platform controls.
3. Be sure the battery pack is connected before operating the machine.
4. Move the UP/DOWN TOGGLE SWITCH according to the markings on the control panel.
1. Turn the KEY SWITCH to PLATFORM CONTROLS.
2. Set the EMERGENCY STOP to the ON position at both the lower and platform controls.
3. Be sure the battery pack is connected before operating the machine.
1. Toggle this switch to the UP position for Lift function.
2. Press and hold the FUNCTION ENABLE SWITCH on the CONTROL HANDLE.
3. Pull the CONTROL HANDLE forward/reverse to raise the platform.
4. Push the CONTROL HANDLE forward/reverse to lower the platform
6.4.1.B TO POSITION PLATFORM
1. Activate the Lifting-functions by pressing the LIFT-FUNCTION BUTTON.
2. Press and hold the FUNCTION ENABLE SWITCH on the CONTROL HANDLE.
3. Pull the CONTROL HANDLE forward/reverse to raise the platform.
4. Push the CONTROL HANDLE forward/reverse to lower the platform
To Next Page
Loading...
