EasyManuals Logo

Godex GS220 User Guide

Godex GS220
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
7
Troubleshooting Guide
The following guide is for reference purposes only. Contact a customer service
representative to preserve the limited warranty terms.
Symptoms Possible Causes Solution
All Interfaces
The unit has no
LEDs, beep or laser.
No power is being
supplied to the
unit.
Check the transformer, the outlet
and power strip. Make sure the
cable is plugged into the unit.
No power is being
supplied to the unit
from host.
Some host systems cannot supply
enough current to power the
scanner. A power supply may be
needed.
At power up the
unit beeps two
times and
alternately flashes
the LEDs.
There is a ROM
failure.
A flash ROM upgrade is required.
At power up the unit
beeps three times.
There is a non-
volatile RAM
failure.
Contact a customer service
representative.
At power up there
is a continuous
razz tone.
There has been a
diagnostic failure.
At power up there
is a razz tone and
the green LED
flashes.
There is a VLD
failure.
At power up there
is a razz tone and
both LEDs flash.
There is a
scanning
mechanism
failure.
The unit scans,
communicates and
beeps twice.
The same symbol
timeout is set too
short.
Adjust the same symbol timeout
for a longer time.
The unit powers up,
but does not beep.
The beeper may
be disabled or no
tone has been
selected.
Enable beeper and select a tone.

Other manuals for Godex GS220

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Godex GS220 and is the answer not in the manual?

Godex GS220 Specifications

General IconGeneral
TypeHandheld bar code reader
Wavelength650 nm
Sensor typeLaser
Scanner type1D
Read rate (max)72 reads/s
Linear (1D) barcodes supportedCodabar, Code 11, Code 128, Code 93, EAN-13, GS1-128 (UCC/EAN-128), JAN, U.P.C.
2D (matrix & stacked) barcodes supportedNot supported
USB version2.0
Standard interfacesUSB
Connectivity technologyWired
CertificationCE, FCC, BSMI
Product colorBlack, Orange
Housing material-
Input voltage5 V
Power consumption (standby)0.675 W
Power consumption (typical)1 W
Storage temperature (T-T)-40 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Weight and Dimensions IconWeight and Dimensions
Depth110 mm
Width70 mm
Height153 mm
Weight120 g

Related product manuals