Godox V100 C - Page 21

50
Touch Screen: Click the “SYNC” icon on both V100 and X3.
When the sender unit and receiver unit are both V100, wireless sync is also
available.
Buttons and Select Dial: Rotate the select dial on V100 to choose “SYNC”
icon, then press the set button. Rotate the select dial on X3 to choose “SYNC”
icon, then press the select dial.
Touch Screen: Slide the screen from the left to the right to make the mode
interface appears, click the “Menu” icon to enter the menu interface. Then
slide from the left to the right to return to the main interface.
Menu
Buttons and Select Dial: Press the power switch button to make the mode
interface appears, rotate the select dial and press the set button to choose
and enter the menu interface. Short press the power switch button to return
to the main interface.
Due to the difference in the menu order of different models, the specic
menu ordering is subject to the actual product models, the following only
explains the menu functions.
Preconditions:
1. Set V100 to receiver mode and the “Receiver” icon on the panel is yellow.
2. Assume flash trigger X3 as the sender.
Sender Wireless Sync