28
Using Automatic Wireless Flash with Multiple Receiver Units
When stronger flash output or more convenient lighting operation is needed, increase
the number of Receiver units and set it as a single Receiver unit. To add Receiver units,
use the same steps as setting “automatic wireless flash with a single Receiver unit”. Any
flash group can be set (A/B/C/D/E). When the number of Receiver units is increased and
the Transmitter unit flash firing is ON, automatic control is implemented to make all
groups of flashes fire the same flash output and ensure the total flash output up is to
standard exposure.
• Press the depth-of-field preview button on the camera to fire a modeling flash.
• If the Receiver unit’s auto power off function is workable, press the Transmitter
unit’s test button to power it on.
Please note that test firing is unavailable during the camera’s regular metering
time.
• The effective time of Receiver auto power off is changeable (C.Fn-RX STBY)
• By making some settings, the auto AF-assist transmitter will not blink after the
Receiver unit’s flash ready indicator is lightened. (C.Fn-AF)
Using Fully Automatic Wireless Flash
The FEC and other setting that set on the Transmitter unit will also be appeared on the
Receiver unit automatically. The Receiver unit does not need any operation. Use the
following settings to make wireless flashes according to the same methods with normal
flash shooting.
• Flash Exposure Compensation
• Flash Exposure Lock
• Manual Flash
• Stroboscopic Flash
To Next Page
Loading...
