Godox V1C - M: Wireless Flash Shooting with Manual Flash; Manual Wireless Flash Setup Guide

29
About the Transmitter Unit
Use two or more Transmitter units. By preparing several cameras that with Transmitter
units flash attached, cameras can be changed in shooting while keeping the same
lighting source. (Receiver unit).
M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You can shoot with a
different flash output setting for each Receiver unit (firing) group. Set all parameters on
the Transmitter unit.
Setting the flash mode to
<M>
Setting flash output.
1/2/3/4<A/B/C/D>
• Press Function
Button < > Turn
the Select Dial to set
the flash output of
the groups. Press
Set Button to
confirm.
Taking the picture.
• Each group fires at
the set flash ratio.
Setting <M> Flash Mode
You can directly operate the Receiver unit to manually set the manual flash or
stroboscopic flash.
1. Setting the Receiver unit.
2. Setting flash mode to <M>
• Press <MODE> button so that <M> is displayed.
• Set the manual flash output.