Gooxi G2SERO-B User Manual

Version: V1.1 76
f) Enter the interface shown in Figure 4-12 and select the disk to configure RAID. [Enabled] means
selected, then select Apply Changes and press Enter. If the state of the disk is JBOD or Unconfigured
Bad, it cannot be selected.
Figure 4- 12
g) Enter the interface shown in Figure 4-13, set the corresponding parameters (see Table for parameter
description), then select Save Configuration and press Enter.
Figure 4- 13

Gooxi G2SERO-B Specifications

General

Brand	Gooxi
Model	G2SERO-B
Category	Motherboard
Language	English