A
DETAIL A
REPEAT FOR OTHER SIDE.
AND 1/4" WASHERS.
PAN HEAD SCREWS
THEN FOLD
THIS TAB UNDER
THE TARP BOARD
AND SECURE IT TO
THE BOTTOM
SIDE OF THE TARP
BOARD WITH
#14 X 1-1/4"
FASTEN OUTSIDE GROMMETS FIRST TO
THE SIDE OF THE TARP BOARD ON
EACH SIDE WITH #14 X 1-1/4"
PAN HEAD SCREWS AND 1/4" WASHERS.
REPEAT FOR OTHER SIDE.
TARP
SIDE. (NOTE IF YOU WISH YOU MAY PREDRILL HOLES FOR THE PAN HEAD SCREW WITH A 1/8" DRILL BIT.)
3: NOW FOLD THE FLAP UNDER THE TARP BOARD AND FASTEN THE GROMMETS UNDER THE TARP BOARD WITH #14
STEP 54: TARP (UPPER LEVEL)
X 1-1/4" PAN HEAD SCREWS WITH 1/4" WASHERS. REPEAT FOR OTHER SIDE. ( NOTE IF YOU WISH YOU MAY
PREDRILL HOLES FOR THE PAN HEAD SCREWS WITH A 1/8" DRILL BIT.)
THE TARP TO THE TARP BOARD WITH #14 X 1-1/4" PAN HEAD SCREWS WITH 1/4" WASHERS. REPEAT FOR OTHER
2: FASTEN THE OUTSIDE CORNERS OF THE TARP TO THE SIDE OF THE TARP BOARD FIRST. ATTACH THE GROMMETS IN
1: PLACE THE TARP (UPPER LEVEL) ACROSS THE TARP BOARDS (UPPER LEVEL) WITH THE HEMS ON THE INSIDE.
NOTE: IF YOU WISH
YOU MAY DRILL
1/8" PILOT HOLES IN THE
TARP BOARD FOR THE
PAN HEAD SCREWS.
To Next Page
Loading...
Need help?
General
