GP3D Root User Manual
14
Notice: If you are not using a raft, only smaller models can be printed.
The platform will need to be adjusted and a layer of textured paper needs
to be applied to the build plate.
4.1.9.10 Some models require support to complete printing, including
external support and overall support. External support refers to additional
printing part added to support the overhanging part on the surface of the
model. As shown below, the external support is needed between the
animal’s chin and the platform.
4.1.9.11 Overall support refers to both internal and external support of
the model.
4.1.9.12 Structure of internal and external support of the model
4.1.9.13 In print parameter settings, check Exterior support and Full
support, as shown below.
4.1.9.14 If some parameters are modified, but you want to use the original
parameters, you can click “Reset” to restore the default settings, as shown
below.
4.1.9.15 Set the print height: directly input Z-axis height in the dialog and
click “Setting”. This value is height of the generated printing file which can
also be set before GP3D Root connection.
To Next Page
Loading...