Engine
16 308870G
Engine
Removal
1. Remove Pinion Assembly/Rotor/Field/Pinion/Clutch,
Clamp and Clutch Housing. See instructions begin-
ning on pages 13.
2. Disconnect all necessary wiring (F
IG. 17).
3. Remove two lock nuts (71) and screws (70) from
base of engine (F
IG. 17).
4. Lift engine carefully and place on work bench.
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
Installation
1. Lift engine carefully and place on cart (FIG. 18).
2. Install two screws (70) in base of engine and secure
with lock nuts (71) (F
IG. 18). Torque to 200 in-lb
(22.6 N.m).
3. Connect all necessary wiring (F
IG. 17).
4. Install Pinion Assembly/Rotor/Field/Pinion/Clutch,
Clamp and Clutch Housing, as instructed on page
14.
FIG. 17
Green
1
2
To the field
To the engine
1
2
71
87
2
FIG. 18
To Next Page
Loading...
