AppendixA-ADM
3A2347ZAA 115
Maintenance
The system will notify the user at the set interval that
maintenance is required. The fields in boxes can be
edited by the user. “Due” and “Current” are both the
number of cycles since the last reset. “Interval” is the set
number of cycles between maintenance notifications.
“Lifetime” is the number of cycles in the lifetime of the
system.
NOTE: The lifetime cycle count will only be reset if the
Advanced Display Module (ADM) is replaced.
Schedule
Use this screen to set times where the system will auto-
matically enable and disable heating. See Select ADM
Settings on page 20.
Advanced 1
Language: Language displayed on the screen.
Date Format: Choose format of the date.
Date: Set the date.
Time: Set the time.
Enter Password: If not “0000”, the Setup screens will
be password protected.
Screen Saver: The screen will go black after the set
amount of time.
Silent Mode: Disable ADM sounds.
Lock Run Screens: Disable setpoint changes on the
run (operation) screens. If the setup screens are pass-
word protected, the setpoints cannot be changed without
first entering the password.
Advanced 2
Temperature Units: Units of measure for displayed
temperatures.
Mass Units: Units of measure for mass.
Distance Units: Units of measure for distance.
To Next Page
Loading...
