Fig. 42
61
68
60
Torque
to 125 in–lb (14 N.m)
B
C
A
0047
Fig.
43
66
61
156
157
64
0048
37
308-105
Clamp
NOTE:
A standard steering wheel puller is re
-
quired to remove the clamp. T
wo 1/4–28 x 3 or 4
in. long screws are also needed.
NOTE:
Refer to Fig. 42.
1. Loosen
the two screws (60) on the clamp (68),
working through the slot at the bottom of the
clutch
housing (61).
2. Install two screws (B) of the tool (A) in two of
the threaded holes in the clamp. T ighten the
screws
(C) until the clamp comes of
f.
3. Skip
ahead to
Reassembly
,
page 38, Step 3,
or
continue below
.
Clutch
Housing
NOTE:
Refer to Fig. 43.
1. Remove the four capscrews (8) and lock-
washers
(48) which hold the clutch housing (2)
to
the engine (1).
2.
Remove the engine key (13).
3.
Pull of
f the clutch housing (2).
4.
Skip ahead to
Reassembly
, page 38,
Step 1.
To Next Page
Loading...
