Pressure Relief Procedure
Pressure Relief Procedure
Follow the Pressure Relief Procedure
whenever you see this symbol.
This equipm
ent stays pressurized until pressure
is manuall
y relieved. To help prevent serious
injury fro
m pressurized fluid, such as skin injection,
splashing
fluid and moving parts, follow the
Pressure
Relief Procedure when you stop spraying
and befor
e cleaning, checking, or servicing
equipme n
t.
The Fusio
n AP gun is shown.
1. Press
to stop the pumps.
2. Turn off all he at zones.
3. Relieve pressure in gun and perform gun
shutdown procedure. See gun manual.
4. Close gun fluid inlet valves A and B.
5. Shut off feed pumps and agitator, if used.
6. Route fluid to waste containers or supply tanks.
Turn PRESSURE RELIEF/SPRAY valves (SA,
SB) to PRES SUR E RE LIE F/CIRCU LA TION
. Ensure gauges drop to 0.
7. Engage gun piston safety lock.
8. Disconnect gun air li ne and remove gun fluid
manifold.
334946A 49
To Next Page
Loading...
Need help?
General
