Startup
6. Press start butt on on the engine c ontrol
modu le twice to start the generator. Verify
voltages are displayed on engine control module
before moving to next step.
The controller will automatically begin glow plug
warming and crank operations. Allow engine to
reach full operating speed.
Note
Engine will not start if main pow er switch
is in the ON position.
7. Turn main po wer switch ON.
The ADM will display the following screen until
com m unicat ion and initialization is complete.
8. For first startup of new system, set system
settings on ADM in Setup Mode.
See Initial System Setup, page 47.
9. For first startup of new system, adjust air settings
to zero:
a. Close the main air shutoff valve (CK).
b. Ens ure all three air regulators are turned fully
counterclock wise.
58 332636D
To Next Page
Loading...
