Maintenance
32 312062A
Maintenance
• Inspect hydraulic and fluid lines for leaks daily.
• Clean up all hydraulic leaks; identify and repair
cause of leak.
• Inspect fluid inlet strainer screens daily, see below.
• Grease circulation valves weekly with Fusion grease
(17773).
• Inspect ISO lubricant level and condition daily, see
page 34. Refill or replace as needed.
• Check hydraulic fluid level weekly. Check hydraulic
fluid level on dipstick (DS). Fluid level must be
between indent marks (IM) on dipstick. Refill as
required with approved hydraulic fluid; see Techni-
cal Data on page 37 and the Approved Anti-Wear
(AW) Hydraulic Oils table in the Reactor
Repair-Parts manual 312063. If fluid is dark in color,
change fluid and filter.
• Change break-in oil in a new unit after first 250
hours of operation or within 3 months, whichever
comes first. See Table 4 for recommended fre-
quency of oil changes
Table 4: Frequency of Oil Changes
• Keep component A from exposure to moisture in
atmosphere, to prevent crystallization.
• Clean gun mix chamber ports regularly. See gun
manual.
• Clean gun check valve screens regularly. See gun
manual.
• Use compressed air to prevent dust buildup on con-
trol boards, fan, motor (under shield), and hydraulic
oil coolers.
• Keep vent holes on bottom of electrical cabinet
open.
ti9879a
Ambient
Temperature
Recommended
Frequency
0 to 90°F
(-17 to 32°C)
1000 hours or 12 months,
whichever comes first
90°F and above
(32°C and above)
500 hours or 6 months, which-
ever comes first
S
DS
ti10003a
ti7861a
IM
To Next Page
Loading...
Need help?
General
