What to do if my Graco Paint Sprayer fluid valve is leaking between the main and outlet housings?
If the fluid valve on your Graco Paint Sprayer is leaking between the main and outlet housings, the O-ring on the seat has likely failed. Replace both O-rings on that seat.
What to do if my Graco Simulation XM fluid valve is leaking at the rod?
If the fluid valve is leaking at the rod of your Graco Paint Sprayer, it is likely due to loose or worn packings. Try tightening the packing nut. If the leak persists, replace the packings.
What to do if the Graco Paint Sprayer does not start when the start button is pressed?
If your Graco Paint Sprayer fails to start when the start button is pressed: * Check for a faulty start switch or wire harness continuity; the switch is normally open circuit. * Check for a faulty stop switch or wiring harness continuity; the stop switch is normally closed circuit.
Why does my Graco Simulation XM have a poor spray pattern?
A poor spray pattern in your Graco Paint Sprayer can be caused by: * Fluid pressure being too low. Increase the metering pump pressure. * Fluid temperature being too low. Increase the fluid temperature. * Spray tip being dirty or worn. Relieve pressure, then clean or replace the tip, following the gun manual instructions. * Mix manifold, mixer, swivel, gun, or hoses partially plugged or too restrictive. Inspect parts for cured material. Clean or replace, or use larger hoses and mixer.
General| Brand | Graco |
|---|---|
| Model | Simulation XM |
| Category | Paint Sprayer |
| Language | English |
To Next Page