Grandstream Networks GHP6 Series - Profiles; General Settings; Network Settings; SIP Settings - Basic Settings

Call Settings
Feature Key
Synchronizat
ion
This feature is used for BroadSoft / Metaswitch call feature synchronization. When it’s set to BroadSoft /
Metaswitch, DND and Call Forward features can be synchronized with BroadSoft / Metaswitch server. The
call forward function will take effect on the server side while the local call forward function is not effective.
The default setting is “Disable”.
Enable
BroadSoft
Call Park
Configures whether to send SUBSRCIRBE message to BroadSoft server to obtain Call Park notifications.
The default setting is “No”.
7Conference
URI
Configures the network-based conference URI (the BroadSoft Standard). If it is configured, end user needs
to tap the N-way key during the conference to transfer the host to the remote media server.
Broadsoft
Call Center
When enabled, Feature Key Synchronization will be enabled regardless of web settings. Default is Disabled.
Hoteling
Event
Enables BroadSoft Hoteling Event feature. Default is Disabled.
Call Center
Status
When set to “Yes”, the phone will send SUBSCRIBE to the server to obtain call center status. Default is
Disabled.
SCA
Enable SCA
(Shared Call
Appearance)
Enables/disables the Shared Call Appearance (the Broadsoft Standard) feature for this account. If it is set to
“Yes”, the phone system can update and share account status with another device. The default setting is
“No”.
NOTE: The Enable SCA settings now supports provision via strings. The value “0” can be replaced with
“line”or “private”; value “1” can be replaced with “shared” or “sharedline”.
Enable
Barge-in
Enables/disables the Barge-In feature. If it is set to “Yes”, the user could
tap the SCA account to barge into an active session with another shared line. The default setting is “No”.
Auto-filling
CallPark
Feature
Code
If it is set to “Yes”, the configured “Call Park Service Code” will be automatically filled in on the phone’s dial
pad when picking up the parked call. This option will be active only if “Special Mode” is set to “Broadsoft”
and “Enable SCA” is set to “Yes”. The default setting is “Yes”.
CallPark
Feature
Code
Configures the pickup feature code for call park. If ” Auto-filling CallPark Feature Code ” is set to “Yes”, this
call park service code will be automatically filled in on the phone’s dial pad when picking up the parked
call. This is used when “Special Mode” is set to “BroadSoft” (from web UI or provisioning) and “Enable SCA”
is set to “Yes”
Line Seize
Timeout (s)
Defines line-seize expiration timer. For Shared Call Appearance, the phone must send a SUBSCRIBE request
for the line-seize event package whenever a user attempts to take the shared line off hook. The default
value is 15 seconds. The valid range is from 15 to 60.
Table 14: Account/Special Features
Phone Settings Page Definitions
Phone Settings/General Settings