Layer 2 QoS
802.1Q/VLAN Tag
(Ethernet) for VoIP
Calls
When Different Networks for Data and VoIP Calls set to Yes, then this option will be applied for
VoIP traffic. Assigns the VLAN Tag of the Layer 2 QoS packets for Ethernet for VoIP Calls. The Default
value is 0.
802.1x Mode
802.1x mode
Enables and selects the 802.1x mode for the phone system. The supported 802.1x modes are: EAP-
MD5, EAP-TLS, EAP-PEAP
The default setting is “Disable”.
802.1x Identity
Enters the identity information for the selected 802.1x mode. (This setting will be displayed only if
802.1 X mode is enabled).
802.1x Secret
Enters the secret for the 802.1x mode. This option will appear when 802.1x mode is EAP-MD5 or
EAP-PEAP.
CA Certificate
Uploads the CA Certificate file to the phone. (This setting will be displayed only if the 802.1 X mode
is enabled)
Client Certificate
Loads the Client Certificate file to the phone. (This setting will be displayed only if the 802.1 X TLS
mode is enabled)
Private Key
Loads the private key file to the phone. (This setting will be displayed only if the 802.1 X TLS mode is
enabled)
Table 20: Network Settings/Ethernet Settings
Wi-Fi Basics
WiFi Function Enables/disables the Wi-Fi feature. The default setting is “Disable”.
WiFi Band
Configures the Wi-Fi frequency band from the list:
2.4G
5G
2.4 G & 5G
Default setting is 2.4G & 5G.
ESSID
Permits to scan and select the available Wi-Fi networks within the range if the Wi-Fi feature is enabled.
Click on “Select” to select the Wi-Fi network to connect to. The ESSID will be auto filled in the ESSID
filed.
Add Network
ESSID Configure the hidden ESSID name.
Security Mode
for Hidden SSID
Defines the security mode used for the wireless network when the SSID is hidden. Default is “None”.
Password Determines the password for the selected Wi-Fi network.
To Next Page
Loading...
