PPPoE Account ID Configures the PPPoE account ID if the PPPoE is used.
PPPoE Password Sets the PPPoE password if the PPPoE is used.
Layer 2 QoS
802.1Q/VLAN Tag
(Ethernet)
Assigns the VLAN Tag of the Layer 2 QoS packets for Ethernet.
The Default value is 0.
Note: When Different Networks for Data and VoIP Calls set to Yes, then this option will be
applied for Data.
Layer 2 QoS
802.1p Priority
Value (Ethernet)
Assigns the priority value of the Layer 2 QoS packets for Ethernet.
The Default value is 0.
Note: When Different Networks for Data and VoIP Calls set to Yes, then this option will be
applied for Data.
The setting needs reboot to take effect.
IPv6
IPv6 Address
Configures the appropriate network settings on the phone.
Users could select from “Auto-configured” or “Statically configured”.
DNS Server 1 Configures the primary DNS IP address.
DNS Server 2 Configures the secondary DNS IP address.
Static IPv6 Address Enter the static IPv6 address in “Statically configured” IPv6 address type.
IPv6 Prefix Length Enter the IPv6 prefix length in “Statically configured” IPv6 address type. Default is 64.
Preferred DNS
Server
IPv4 Address Type
Users could select “DHCP” or “Static IP”.
• DHCP: Obtain IP address via a DHCP server in the LAN. All domain values for static IP/PPPoE are
unavailable, even though the values have been saved in the flash.
• Static IP: Manually configures IP Address, Subnet Mask, Default Router’s IP Address, DNS Server 1
and DNS Server 2.
By default, it is set to “DHCP”.
IP Address Defines the phone’s static IP address if the static IP is used.
Subnet Mask Determines the network’s subnet mask if the static IP is used.
Default Gateway Defines the network’s gateway address if the static IP is used.
DNS Server 1 Configures the primary DNS IP address if the static IP is used.
DNS Server 2 Configures the secondary DNS IP address if the static IP is used.
To Next Page
Loading...
