Specifies the time interval, in seconds, between successive LLDP-MED transmission cycles
Layer 3 SIP QoS
This field defines the layer 3 QoS parameter for SIP packets.
This is the value used for IP Precedence, Diff-Serv or MPLS. The Default value is 26.
Layer 3 Audio QoS
This field defines the layer 3 QoS parameter for audio packets. This is the value used for IP Precedence, Diff-Serv or MPLS. The
Default value is 46.
Layer 3 Video QoS
This field defines the layer 3 QoS parameter for video packets. This is the value used for IP Precedence, Diff-Serv or MPLS. The
Default value is 34.
Second Layer QoS 802.1Q/VLAN tag (Ethernet)
This field contains the value used for layer 2 VLAN tagging for the Ethernet network. The Default value is 0.
Second Layer QoS 802.1p/Priority Value (Ethernet)
This assigns the priority value of the Layer 2 QoS packets on the Ethernet Network. The Default value is 0.
Proxy Settings
For some network setup, it is required to connect to the Internet via proxy server. Manually configure “Proxy hostname”,
“Proxy port” and “Bypass proxy for” in proxy settings for the phone to get Internet connection successfully.
Tethering & Portable Hotspot
The GXV3350 can serve as a Wi-Fi access point for other devices to provide wireless access to the network if the Portable Wi-
Fi hotspot is turned on.
1. Turn on hotspot by tapping on “Portable Wi-Fi hotspot”. Icon will show on the top status bar.
2. Tap on “Set up Wi-Fi hotspot” to configure network SSID, security type and password. Please make sure the password has
at least 8 characters. Otherwise, users won’t be able to save the setting.
3. Tap on “Hotspot & tethering settings” and choose either to set up the hotspot for IPV4 only or for IPV4 & IPV6
4. On the other device that needs Wi-Fi access, turn on Wi-Fi, look for the SSID of the GXV3350 hotspot and enter
authentication information to get connected.
To Next Page
Loading...
