Grandstream Networks GHP6 Series - Hunting Group Type; Hunting Group Ring Timeout; Call Features Settings; Enable Call Features

Priority
Listening
Address
Label
Configures the IP address and port number for monitoring multicast paging call. When the initiator
initiates a call, answer the call and display listening address and tag of the monitoring target. This feature
supports Video Multicast, when the initiator initiates Video Multicast, it will automatically add the number
2 on the port of the listening address. Reboot the phone to make changes take effect.
The valid IP address range is from 224.0.0.0 to 239.255.255.255. Users may also fill the label for each
listening address corresponding to priority.
Table 19: Phone Settings/Multicast Paging
Network Settings Page Definitions
Network Settings/Ethernet Settings
Ethernet Settings
IP Mode
If IPv4 is selected, the phone will be using IPv4 addressing, otherwise, it will be using IPv6
addressing. Default is Prefer IPv4.
Different
Networks for Data
and VoIP Calls
Configures whether to set up different networks for the phone data and the call. If set to “Yes”, you
need to configure the data network and VoIP network respectively.
IPv4
IPv4 Address Type
Configures the appropriate network settings on the phone.
Users could select from “DHCP”, “Static IP” or “PPPoE”(Point-to-point Protocol over Ethernet). By
default, it is set to “DHCP”.
DHCP VLAN
Override
Selects the DHCP Option VLAN mode. When set to “DHCP Option 132 and DHCP option 133”, the
phone will get DHCP option 132 and 133 as VLAN ID and VLAN priority. When set to “Encapsulated
in DHCP Option 43”, the phone will get values from Option 43 which encapsulate VLAN ID and VLAN
priority.
Note: Please make sure the “Allow DHCP Option 43 and Option 66 to Override Server” setting under
maintenance🡪upgrade is checked. The default setting is ” Encapsulated in DHCP Option 43 “.
DHCP Host name
(Option 12)
Sets the name of the client in the DHCP request. It is optional but may be required by some Internet
Service Providers.
Vendor Class ID
(Option 60)
Configures the vendor class ID header in the DHCP request.
The default setting is Grandstream GXV3380.
IP Address Defines the phone’s static IP address if the static IP is used.
Subnet Mask Determines the network’s subnet mask if the static IP is used.
Default Gateway Defines the network’s gateway address if the static IP is used.
DNS Server 1 Configures the primary DNS IP address if the static IP is used.
DNS Server 2 Configures the secondary DNS IP address if the static IP is used.