Grandstream Networks GHP6 Series - Using the Phone Stand

Figure 1: GXV3350 Package Content
Connecting and Setting Up the GXV3350
The GXV3350 can be installed on the desktop using the built-in stand or attached on the wall using the slots for wall
mounting.
Using the Phone Stand
The GXV3350 has a phone stand. To set up the GXV3350 as your desk phone, follow the steps below:
1. For installing the phone on the table with the phone stand, attach the phone stand to the bottom of the phone where
there is a slot for the phone stand, (upper half, bottom part);
2. Connect the handset and main phone case with the phone cord;
3. Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a router (LAN side of the router) using the
Ethernet cable;
4. Connect the 12V DC output plug to the power jack on the phone; plug the power adapter into an electrical outlet. If PoE
switch is used in step 3, this step could be skipped;
The LCD will display the booting up screen or firmware upgrading information. Before con tinuing, please wait for the main
screen display to show up.
Figure 2: Phone Stand on GXV3350
Using the Slots for Wall Mounting (Wall Mount *Sold separately)
Note
Check the package before installation. If you find anything missing, contact your system administrator.
Note
The 2 positions of the Phone Stand for GXV3350: One angle is 49.5°, and the other is 44.5°, between the device LCD interface
and the horizontal plane.