Enable TR-069
Sets the phone system to enable the “CPE WAN Management Protocol” (TR-069).
The default setting is “No”.
ACS URL Specifies URL of TR-069 ACS (e.g., http://acs.mycompany.com), or IP address.
ACS User Name Enters username to authenticate to ACS.
ACS Password Enters password to authenticate to ACS.
Periodic Inform Enable Sends periodic inform packets to ACS. Default is “No”.
Periodic Inform Interval (s) Configures to sends periodic “Inform” packets to ACS based on specified interval.
Connection Request User Name Enters user name for the ACS to connect to the phone.
Connection Request Password Enters password for the ACS to connect to the phone.
Connection Request Port Enters the port for the ACS to connect to the phone.
CPE Cert File Uploads Cert File for the phone to connect to the ACS via SSL.
CPE Cert Key Uploads Cert Key for the phone to connect to the ACS via SSL.
Table 28: System Settings/TR-069
Firmware
Upgrade via Manually Upload
Complete Upgrade If enabled, all files will be replaced except user data. Default is disabled.
Upload Firmware File to Update Allow users to load the local firmware to the phone to update the firmware.
Upgrade via Network
Firmware Upgrade Mode
Allow users to choose the firmware upgrade method: TFTP, HTTP, HTTPS or
Manual Upload. The default setting is “HTTP”.
Firmware Server Path
Set the IP address or domain name of firmware server. The URL of the server that
hosts the firmware release. Default is “fm.grandstream.com/gs”.
To Next Page
Loading...
