Separate
Ethernet &
Wi-Fi Traffic
Configures whether to separate Ethernet & Wi-Fi traffic. If enabled, VoIP calls are forced to use Ethernet,
and other application data preferentially use Wi-Fi. Note: To make it take effect, please ensure that the
network environment is configured correctly.
The default setting is No.
Maximum
Transmission
Unit (MTU)
Configures the MTU in bytes. Please set MTU reasonably according to your needs. Note: If MTU is set to
less than 1280, IPv6 may not take effect.
PC Port Mode
PC Port Mode
Enables and defines the PC port mode. If it is set to “Mirrored”, the traffic in the LAN port will go through
PC port as well and packets can be captured by connecting a PC to the PC port. The default setting is
“Enable”.
PC Port VLAN
Tag
Defines the VLAN Identifier of the Layer 2 frame for PC port.
This adds the VLAN tag value on the target address received from the LAN port of the phone then sends
the value to the device connected to the PC port.
Note: VLAN tag value on the device connected to the PC port should be the same as the VLAN tag value
assigned to the PC port here.
PC Port
Priority Value
Determines the Priority Code Point within a Layer 2 frame header for PC port.
Proxy
HTTP/HTTPS
Proxy
Hostname
Configures the HTTP/HTTPS proxy URI of the network. Some of networks requires going through a proxy
to access to the Internet. The default setting is keeping this field blank.
HTTP/HTTPS
Proxy Port
Configures the HTTP/HTTPS proxy port number of the network. Some of networks requires going through
a proxy to access to the Internet. The default setting is keeping this field blank.
Bypass Proxy
For
Defines the specific URI that the phone can directly access to without HTTP/HTTPS proxy. If it is filled, the
phone will bypass the proxy to send the packets to the specific URI. The default setting is filed blank.
Note: This option allows IP range, for example: 192.168.1.0/24
Remote
Control
CSTA Control
Indicates whether CSTA Control feature is enabled. Change of this configuration will need the system
reboot to make it take effect.
Action URI
Support
Configures whether the phone is enabled to receive and handle Action URI request.
Remote
Control Pop
up Window
Support
Configures whether the phone is enabled to pop up allow remote control window. If set to “Yes”, when
the remote console is connected to the phone, the phone will pup up a window to allow remote control
or not. If set to “No”, once the remote console successfully connect s to the phone, it can directly control
the phone remotely.
Action URI
Allow IP List
List of allowed IP addresses from which the phone receives the Action URI. If input “any”, any remote
console can access this phone.
To Next Page
Loading...
