Web/SSH
Access
Enable SSH Enables SSH access to the phone. Default setting is “Yes”.
SSH Port Customizes SSH port. Valid range: 1 – 65535. Default is 22.
Access
Method
Determines which protocol will be used to access the phone ‘s Web GUI. It can be selected from HTTP
and HTTPS. The default setting is HTTP.
Port
Specifies which port to use to access the phone ‘s Web UI. By default, if HTTP, the port number will be 80;
if HTTPS is selected, the port number will be 443.
Web Access
Control
Configures Web access control by using Whitelist or Blacklist on incoming IP addresses.
Default setting is None.
Web Access
Control List
Only allow the list of IP addresses as Whitelist, or restrict the list of IP addresses as Blacklist to access
Web.
Configuration
via Keypad
Menu
Configures access control for keypad Menu settings on the Settings interface of the phone.
Unrestricted: configure all settings on the Settings interface;
Basic Settings Only: The Advanced Settings option will not be displayed;
Basic Settings & Network Settings: Only the Advanced Settings option will not be displayed
Constraint Mode: users need to input admin user password to configure Wireless & Network and
Advanced Settings.
Warning: If the admin password is lost while constraint mode is enabled, your device may become
permanently unusable. Remember to be careful when using constraint mode to avoid irreversible
damage.
Note: When access control for keypad is limited to “Basic Settings Only” or “Constraint Mode”, the
Admin authentication will be mandatory to start Factory Reset process.
Permission to
Install/Uninsta
ll Apps
Configures the permissions for users to install/uninstall the applications.
If set to “Allow“, the user is free to install/uninstall third-party apps.
If set to “Require admin password“, the user need to input the correct administrator password to
install/uninstall third-party apps.
If set to “Require admin password if the app source is unknown“, the user need to input admin
password only when install apps from unknown source, administrator password authentication is
required when the user uninstall third-party apps.
If set to “Not allow“, the user cannot install/uninstall third-party apps.
User Info
Management
Current Admin
Password
Enter current logged-in user’s password. This field is case sensitive. (The default random password can be
found at the sticker on the GXV3350)
New Admin
Password
Allows the user to change the admin password. The password field is purposely blank after clicking the
“Save” button for security purpose. This field is case sensitive with a maximum length of 32 characters.
To Next Page
Loading...
