Door
System
Type
Set the door system type to “GDS” if the GDS door system is used, or set it to “Baudisch” if another door
system brand is used.
Note: Each GDS door system has 2 different access passwords to control 2 doors separately named as
[Related Display Name1] & [Related Display Name2] below for door 1 and 2 respectively.
System
Number
Specifies the door system number which is the SIP user ID configured on door system or its IP address, if the
door system is using IP call. It enables to show open door button when caller number or IP address matches
with this setting. e.g:”36311″ or “192.168.124.81”.
Note: When set “Door System Type” to “Baudisch” a “configure” button will appear to allow user to configure
groups of door system URL and User ID for 100 entries.
System Number: This is used to configure the User ID of door system. Once configured, only the call
from this User ID would use door system while other calls use the default mode.
System Address: This is used to input the IP address or URL of the system in order to identify the call
from door system.
Users can set HTTP authentication credentials on the URL for Door Systems that require authentication to
send HTTP stream. The URL format will be similar to the following:
http://username:password@192.168.1.150/goform/stream?cmd=get&channel=4
Display
Name
Configures the display name of the door system. When the call matches the configured system number, the
name will be displayed on LCD.
Related
Display
Name1
Configures the name that will be displayed on LCD for door 1 when the call matches the configured GDS door
system number.
Access
password
Determines the door system password which should match the one configured on the used door system
settings. In case the GDS is set as ‘Door System type’ parameter, the password should match the one
configured on the GDS to open door 1.
Related
Display
Name2
Indicates the name that will be displayed on LCD for door 2 when the call matches the configured system
number.
Access
password
The configured password should match the one configured on the GDS to open door 2.
System
Ringtone
Allows users to configure the ringtone for the door System. Users can choose different ringtones from the
dropdown list.
DTMF
Content
Set the DTMF content that is going to be sent when the DTMF button is pressed under Call screen🡪“Keypad”.
Table 38: Value-added Service
Display Open Door
Button When
Calling
Configures whether display Open Door button when there is an incoming call. If set to “Yes”, you
cannot open door with DTMF when preview function is disabled, the phone will hide open door
button automatically.
Enable Preview
Configures whether to enable preview function or not. If set to “No”, you can not open door with
DTMF when there is an incoming call, the phone will hide open door button automatically.
Table 39: Value-added Service/General Settings
To Next Page
Loading...
