Note: Auto Answer Numbers can be split with ";", for example:
1x;2xxx;3x+
Intercom
Play warning tone for Auto Answer
Intercom
When enabled, the phone will play warning tone when auto answer Intercom.
The default value is “Yes”.
Custom Alert-Info for Auto Answer
Allows to customize Alert-Info header for auto answer. The phone will auto answer
only if matching content of the custom Alert-info header.
Allow Auto Answer by Call-Info/Alert-
Info
Allows the phone to automatically turn on the speaker phone to answer incoming calls
after a short reminding beep when enabled, based on the SIP Call-Info/Alert-Info
header sent from the server/proxy.
Default is “Yes”.
Allow Barging by Call-Info/Alert-Info
When enabled, the phone will automatically put the current call on hold and answer the
incoming call based on the SIP Call-Info/Alert-Info header sent from the server/proxy.
However, if the current call was answered based on the SIP Call-Info/Alert-Info header,
then all other incoming calls with SIP Call-Info/Alert-Info headers will be rejected
automatically.
Default setting is “No”.
Mute on answer Intercom call
When enabled, the phone will mute the incoming intercom call.
The default value is “No”.
Transfer
Transfer on Conference Hang-up
If set to “Yes”, when the phone hangs up as the conference initiator, the conference call
will be transferred to the other parties so that other parties will remain in the conference
call.
The default setting is “No”.
Enable Recovery on Blind Transfer
Disables recovery to the call to the transferee on failing blind transfer to the target. The
default setting is “Yes”.
Notes:
1. This feature only applies to blind transfer.
2. This feature depends on how server handles transfer. If there is any NOTIFY from
server, this feature won’t take effect. If server responds 4xx, phone should try to
recover regardless of this option.
3. During blind transfer, after transferor received 200/202 for REFER, but there is no
NOTIFY from server after 7 seconds, transferor will decide to recover the call with
transferee or not depending on the options. This is the only case that this option will
be applied.
Blind Transfer Wait Timeout
Defines the timeout (in seconds) for waiting SIP frag response in blind transfer. Valid
range is 30 to 300.
Default setting is “30”.
Refer-To Use Target Contact
If set to “Yes”, the “Refer-To” header uses the transferred target’s Contact header
information for attended transfer.
The default setting is “No”.
Hide Dialing Password
Allows users to hide the password when the dialing number matches the configured
prefix.
● Prefix for Dialing Password
● Password Length
To Next Page
Loading...
Need help?
General
