Grandstream Networks GRP26 Series Administration Guide

Table 16: Phone Settings Page Definitions
Network Page Definitions
Important: The Priority goes as: Contact Ring Tone 🡪 Account Ring Tone 🡪 Default Ring
Tone.
Provision
Total Number of Custom Ringtone
Update
Configures the number of custom ringtones to update in the provisioning process. The default
setting is 3. The valid range is 0 - 10.
Settings 🡪 Multicast Paging
Multicast Paging Function Enable or disable multicast paging. The default setting is "No".
Allowed in DND Mode
Allow Multicast Paging when DND mode is enabled.
Default Setting is “No”.
Paging Barge
During active call, if incoming multicast page is higher priority (1 being the highest) than this
value, the call will be held and multicast page will be played.
The default setting is “Disabled”.
Paging Priority Active
If enabled, during a multicast page if another multicast is received with higher priority (1
being the highest) that one will be played instead.
The default setting is “Enabled”.
Multicast Channel Number
Multicast Channel Number (0-50). 0 for normal RTP packets, 1-50 for Polycom multicast
format packets.
Multicast Paging Codec
The codec for sending multicast pages, there are 5 codecs could be used: PCMU, PCMA,
G.726-32, G.729A/B, G.722 (wide band), G.723.1.
Default setting is “G.722(wide band)”.
Multicast Sender ID Outgoing caller ID that displays to your page group recipients (for multicast channel 1 – 50).
Multicast Listening
Defines multicast listening addresses and labels. For example:
● “Listening Address” should match the sender’s Value such as: “237.11.10.11:6767”
● “Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our Website.
Network Settings 🡪 Ethernet Settings
Internet Protocol
Selects “IPv4 Only”, “IPv6 Only”, “Both, prefer IPv4” or “Both, prefer IPv6”. The default
setting is “IPv4 only”.
IPv4 Address
IPv4 Address
Allows users to configure the appropriate network settings on the phone to obtain IPv4
address. Users could select “DHCP”, “Static IP” or “PPPoE”. By default, it is set to “DHCP”.
Host name (Option 12)
Specifies the name of the client. This field is optional but may be required by Internet Service
Providers.
Vendor Class ID (Option 60) Used by clients and servers to exchange vendor class ID.

Grandstream Networks GRP26 Series Specifications

General

Brand	Grandstream Networks
Model	GRP26 Series
Category	IP Phone
Language	English