Early Dial
Selects whether to enable early dial. If it’s set to “Yes”, the SIP proxy must support 484
responses. Early Dial means that the phone sends for each pressed digit a SIP INVITE
message to SIP server. SIP server considers its extensions and, if no match happened
yet, it sends back a “484 Address Incomplete” message. Otherwise, it executes the
action.
The default setting is “No”.
Call Forward
Enable Forward All If set to "Yes", all calls will be forwarded to the number specified below.
All To Specifies the number to be forwarded to when enabled Forward all.
Enable Busy Forward If set to "Yes", call will be forwarded to the number specified below on busy.
Busy To Specifies the number to be forwarded to for Call Forward On Busy.
Enable No Answer Forward Specifies the number to be forwarded to for Call Forward On Busy.
No Answer To Specifies the number to be forwarded to for Call Forward On Busy.
No Answer Timeout (s)
Specifies the number to be forwarded to for Call Forward On Busy.
The default value is 12 seconds.
The valid range is 1 to 120.
Dial Plan
Dial Plan Prefix Configures a prefix added to all numbers when making outbound calls.
Bypass Dial Plan
Enable/Disable the dial plan bypass while dialing through:
● Contact
● Call History Incoming Call
● Call History Outgoing Call
● Dialing Page
● MPK
● API
The default setting is “MPK”.
Dial Plan A dial plan establishes the expected number and pattern of digits for a telephone
number. This parameter configures the allowed dial plan for the phone. Default setting
is “{ x+ | +x+ | *x+ | *xx*x+ }”.
Dial Plan Rules:
1. Accepted Digits: 1,2,3,4,5,6,7,8,9,0, *, #, A,a,B,b,C,c,D,d;
2. Grammar: x – any digit from 0-9;
● Grammar: x – any digit from 0-9;
● Grammar: X – any character from 0-9, a-z, A-Z.
● xx+ – at least 2-digit numbers
● xx – only 2-digit numbers
● ^ – exclude
● [3-5] – any digit of 3, 4, or 5
● [147] – any digit of 1, 4, or 7
● <2=011> – replace digit 2 with 011 when dialing
● | – the OR operand
● , – second dial tone. For example: {0,x+} will play second dial tone after dialing 0
and all digits will be sent including 0
● {X123} — match Z123, e123, 5123, …
● Flag T when adding a “T” at the end of the dial plan, the phone will wait for 3
seconds before dialing out. This gives users more flexibility on their dial plan
To Next Page
Loading...
Need help?
General
