Grandstream Networks GRP2616 Administration Guide

GRP2600 Administration Guide
Version 1.0.5.15
P a g e | 61
Automatic Redial
Interval
The interval between each call attempt using Automatic Redial feature. The
valid range is 1 – 360. The default value is “10”.
Bypass Dial Plan
Through Call History
and Directories
Enable/Disable the dial plan check while dialing through the call history and
any phonebook directories. The default setting is “No”.
Disable Call Waiting
Disables the call waiting feature.
The default setting is “No”.
Disable Call Waiting
Tone
Disables the call waiting tone when call waiting is on.
Default setting is “No”.
Ring For Call Waiting
Disables / enables ringing instead of playing call-waiting tone when audio is
on handset or headset. The default setting is “No”.
Disable Busy Tone on
Remote Disconnect
Disables the busy tone heard in the handset when call is disconnected
remotely. The default setting is “No”.
Disable Direct IP Call
Disables Direct IP Call.
The default setting is “No”.
Use Quick IP Call
mode
When set to “Yes”, users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address.
To dial quick IP call, off hook the phone, press # to switch to “Direct IP Call”
mode and dial XXX (X is 0-9 and XXX <=255), phone will make direct IP call
to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address
REGARDLESS of subnet mask. XX or X are also valid so leading 0 is not
required (but OK). No SIP server is required to make quick IP call. The
default setting is “No”.
Disable Conference
Disables the Conference function.
The default setting is “No”.
Disable in-call DTMF
Display
Enables/disables the display of entered DTMF digits on the phone LCD
during the call.
The default setting is “No”.
Enable Sending DTMF
via specific MPKs
Allows certain MPKs to send DTMF in-call. This option doesn’t affect Dial
DTMF.
The default setting is “No”.
Disable Active MPK
Page
When option is enabled, Active MPK Page on the extension boards will be
disabled.
The default setting is “No”.
Enable Active VPK
Page
Enables Active VPK Page to be displayed on LCD when there are active
VPKs.
The default setting is “No”.
Enable DND Feature
If set to “No”, the user cannot turn on Do Not Disturb feature via MUTE key,
MPK, or menu on LCD.
The default setting is “Yes”.

Grandstream Networks GRP2616 Specifications

General

Brand	Grandstream Networks
Model	GRP2616
Category	IP Phone
Language	English