GRP2600 Administration Guide
Version 1.0.5.15
call feature will be handled by Broadsoft server, not by the phone.
Configures DND feature code to turn on DND.
Configures DND feature code to turn off DND.
Call Forward
Unconditionally (All)—
On
Configures Call Forward All feature code to activate unconditional call
forwarding.
Call Forward
Unconditionally (All)—
Off
Configures Call Forward All feature code to deactivate unconditional call
forwarding
Configures the extension that the call will be forwarded to.
Configures Call Forward Busy feature code to activate busy call forwarding.
Configures Call Forward Busy feature code to deactivate busy call
forwarding.
Configures the extension that the call will be forwarded to.
Call Forward Delayed
(No Answer)—On
Configures Call Forward Delayed feature code to activate no answer call
forwarding.
Call Forward Delayed
(No Answer)—Off
Configures Call Forward Delayed feature code to activate no answer call
forwarding.
Configures the extension that the call will be forwarded to.
Delayed Call Forward
Wait Time
Defines the timeout (in seconds) before the call is forwarded on no answer.
The default value is 20 seconds. The valid range is 1 to 120.
Allows users to swap the two accounts that they have configured. This will
Increase the flexibility of account management.
Note: Make sure to press “Start” to complete the process.
Settings Page Definitions
Table 11: Settings Page Definitions
Settings → General Settings
This parameter defines the local RTP port used to listen and transmit. It is
the base RTP port for channel 0. When configured, channel 0 will use this
port _value for RTP; channel 1 will use port_value+2 for RTP. Local RTP
port ranges from 1024 to 65400 and must be even. Default value is 5004.