GRP2600 Administration Guide
Version 1.0.5.15
Network → WiFi Settings (Available on GRP2612W & GRP2614 & GRP2615 & GRP2616 only)
Enables / Disables the WiFi on the phone. Three options are available:
• No: Disables WiFi. User has ability to enable WiFi from LCD Menu.
• Off & Hide Menu from LCD: Disables WiFi and hides “WiFi
Settings” menu from phone LCD.
• Yes: Enables WiFi to connect to WiFi network.
Default setting is “No”.
Specifies the Wi-Fi encryption type.
Enters WiFi SSID name to connect.
Configures the authentication password to access WiFi
Network.
Specifies the WiFi encryption type. The available options are
the following: None, WEP, WPA, WPA Enterprise and Auto.
Default settings is None.
Maintenance Page Definitions
Table 13 : Maintenance Page Definitions
Set new password for web GUI access as User. This field is case sensitive.
Enter the new User password again to confirm.
The current admin password is required for setting a new admin password.
Set new password for web GUI access as Admin. This field is case sensitive.
Enter the new Admin password again to confirm.
Maintenance → Upgrade and Provisioning
Firmware Upgrade
and Provisioning
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check.
The default setting is “Always Check for New Firmware”.
Always Authenticate
Before Challenge
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials
before being challenged by the server. The default setting is “No”.
Validate Hostname
in Certificate
Allows to validate the hostname in the SSL certificate.
The default setting is “No”.
Allow DHCP Option
43 and Option 66
Override Server
DHCP option 66 originally was only designed for TFTP server. Later on, it was
extended to support an HTTP URL. GRP phones support both TFTP and HTTP
server via option 66. Users can also use DHCP option 43 vendor specific
option to do this.
To Next Page
Loading...
Need help?
General
