GRP2600 Administration Guide
Version 1.0.5.15
Syslog will be filtered based on keywords provided. If you enter multiple
keywords, it should be separated by ‘,’. Please note that no spaces are
allowed.
Configures whether the SIP log will be included in the syslog messages. The
default setting is “No”.
Note: By setting Send SIP Log to Yes, the phone will still send SIP log from
syslog even when Syslog Level set to NONE.
Show Internet Down
Message
If enabled, the internet down warning message will display when internet is
down. The default setting is “No”.
Auto Recover From
Abnormal
If set to “Yes”, the phone will automatically recover when running abnormal.
The default setting is “Yes”.
Specifies URL of TR-069 ACS (e.g.,http://acs.mycompany.com), or IP
address. Default setting is “https://acs.gdms.cloud”
Enables periodic inform. If set to “Yes”, device will send inform packets to the
ACS. The valid range is 1 – 4294967295. The default setting is “Yes”.
Sets up the periodic inform interval to send the inform packets to the ACS. The
default value is “86400”.
Connection Request
Username
The username for the ACS to connect to the phone.
Connection Request
Password
The password for the ACS to connect to the phone.
The port for the ACS to connect to the phone. The default value is “7547”.
The Cert File for the phone to connect to the ACS via SSL.
The Cert Key for the phone to connect to the ACS via SSL.
When enabled, this option allows users to randomize the sending of TR069
INFORM packets. The default setting is “Disabled”.
Maintenance → Security Settings→ Security
Configuration via
Keypad Menu
Configures the access control for the users to configure from keypad Menu.
There are three different options:
• Unrestricted: All the options can be accessed in keypad Menu.
• Basic settings only: The SIP option under Phone submenu, and
Network, Upgrade, UCM Detect and Factory Reset options under System
submenu will not be available in LCD Menu.
To Next Page
Loading...
Need help?
General
