Grandstream Networks GXW-4024 - Call Features

Grandstream Networks, Inc. GXW4024 User Manual Page 16 of 35
Firmware 1.0.1.8 Last Updated: 5/2008
CALL FEATURES
The GXW4024 supports the traditional telephony features available in a PBX as well as additional
advanced telephony features.
T
ABLE 6: CALL FEATURES TABLE (STAR CODE)
Key Call Features
*30 Block CallerID (for all-config change)
*31 Send CallerID (for all-config change)
*67 Block CallerID (per call)
*82 Send CallerID (per call)
*47 Direct IP Calling. Dial “*47” + “IP address”. No dial tone will be played in the middle. Detail see
Direct IP Calling section on page 12.
*50 Disable Call Waiting (for all-config change)
*51 Enable Call Waiting (for all-config change)
*69 Call Return Service: Dial *69 and the phone will dial the last incoming phone number received.
*70 Disable Call Waiting (Per Call)
*71 Enable Call Waiting (Per Call)
*72
Unconditional Call Forward: Dial “*72” and then the forwarding number followed by “#”. Wait
for dial tone and hang up. (dial tone indicates successful forward)
*73 Cancel Unconditional Call Forward: Dial “*73” and wait for dial tone, then hang up.
*74
Enable Paging Call: Dial “*74” and then the destination phone number you want to activate in
Paging mode.
*78 Enable Do Not Disturb (DND): When enabled all incoming calls will be rejected.
*79 Disable Do Not Disturb (DND): When disabled, incoming calls will be accepted.
*87 Blind Transfer
*90
Busy Call Forward: Dial “*90” and then the forwarding number followed by “#”. Wait for dial tone
then hang up.
*91 Cancel Busy Call Forward: dial “*91”. Wait for dial tone. Hang up.
*92
Delayed Call Forward: Dial “*92” and then the forwarding number followed by “#”. Wait for dial
tone then hang up.
*93 Cancel Delayed Call Forward: Dial “*93” for a dial tone, then hang up.
Flash/Hook If user hears call waiting beep, flash/hook will switch to the new incoming call. Also used to switch
to a new channel for a new call.
# Pressing pound sign will serve as Re-Dial key.