GRAPHTEC CE5000-120 - Page 63

CE5000-UM-251-9370 6-25
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the Y-motor
(1) AttachthepulleyangeandthespacertothenewY-motor.
(2) AttachtheY-motortotheY-motorbracket.
(3) HangtheY-drivebeltontheY-motorpulleyandtheY-idlerpulley.
(4) AttachtheY-motorpulleytotheY-motor.
(5) TightenthetwoM3L4WPsetscrewsthatholdtheY-motorpulley.
(6) SpreadasuitablequantityofLoctite222onthetwoM3L4WPsetscrewsthatholdtheY-motorpulley.
(7) SpreadasuitablequantityoftheShinetusilicongreaseG501ontheY-motorpulleyandY-idlerpulley.
(8) UsetheforcegaugetopulltheY-drivemotorpulleyangewitha1.2kgto1.3kgforce.
(9) TightenthethreeM3L6bindingheadscrewsthatholdtheY-motor.
(10) MovethepenblockandcheckthetensionoftheY-drivebelt.
(11) Reattachtheotherpartsinthereverseorderinwhichtheyweredetached.