GRAPHTEC CE5000-120 - Page 75

CE5000-UM-251-9370 6-37
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the drive roller
(1) Reattach in the reverse order in which it was detached.
(2) SpreadasuitablequantityofLoctite222ontheM3L4WPsetscrewholdingtheX-drivepulley.
(3) UsetheforcegaugetopulltheX-drivemotorpulleyangewitha1.2kgto1.3kgforce.
(4) Tighten the mounting screws that hold the X-motor.
(5) SpreadasuitablequantityoftheShinetusilicongreaseG501ontheX-motorpulley.
(6) MovetheX-drivepulleyandcheckthetensionoftheX-drivebelt.
(7) ConrmtheYrailmountingposition(seethesubsection6.2.19).
(8) Adjustthedriverollerheight(seethesubsection6.2.20).
(9) Reattachtheotherpartsinthereverseorderinwhichtheyweredetached.