GRAPHTEC CE5000-120AP - Setting the ORIGIN POINT

CE5000-UM-251-9370 6-42
6 DISASSEMBLY AND REASSEMBLY
Adjusting the height of the grid roller
(1) Positionthepinchrollerstothespeciedlocation.(FortheCE5000-40/60positionthecenteronly.)
(2) Lowerthepinchrollers.
Gridrollersupportbracket
Adjustingposition1
Y-rail
Positionthecenterpinchrollerhere.
Positiontherightpinchrollerhere.
Positiontheleftpinchrollerhere
whenadjustingattheadjusting
position1.
Adjustingposition2
Adjustingposition3
Adjustingposition4
Positiontheleftpinchrollerhere
whenadjustingattheadjusting
position2.
(3) Adjustthegridrollershaftheightfromtheadjustingposition1bythetwoscrewsholdingthegridroller
supportbracket.Don'ttightenthethosescrewstootightbecausethreadofscrewsbrakes.
(4) Adjustthegridrollershaftheighttobe74mmbetweenthegridrollershafttotopoftheYrailasshown
inthepicturebelow.
74 mm
Y-rail
Grid roller
Adjustthesescrewsto
adjustthehight
Y-rail
Heightadjustmentjig