CAUTION
•
The media must be at least 125 mm in length
in media feed direction.
•
The media must always be positioned over
the media sensor.
For minimum width media
The CE6000-120AP can take media of 594 mm (A1 size) or more.
Changing the Hold-down Force
The down force applied by the middle 3 push rollers can be changed depending on the width and type of media used.
When using the genuine Graphtec paper, please set the force of the middle push roller to "Normal" and the remaining 2 rollers to "Low" (OFF).
Media sensor
Grit roller
Push roller
Left-hand push roller
Right-hand push roller
Normal
Low (OFF)
Low (OFF)
CAUTION
Hold-down force can not be switched for side
push rollers.
Supplement
Switch the hold-down force as necessary for
different types of media.
Switching
(1) Lower the media set lever to raise the push rollers.
(2) Use the push roller hold-down force switching lever on the back of the push roller to
adjust the center push roller's hold-down force. It can be set to Normal or Low (OFF).
(3) When the push roller hold-down force switching lever is up, it is in Normal menu.
When it is down, it's Low (OFF).
Hold-down force:
Normal
Hold-down force:
Low (OFF)
Lever Lever
4. About the Initial Setup screen
The Initial Setup screen appears only when powering up the Cutting Plotter for the rst time after purchase. Here, you can set "Display
Language" and "Length Unit".
After the initial setup is completed, you can also select the menu from the READY status.
See "2.6 Connecting to the Power"
P.2-20
for turning on the power.
1
Once the machine is powered on (with the " | " switch) a message will be displayed after the version is displayed.
DISPLAY LANGUAGE setting screen is displayed.
2
Use the POSITION (
)
keys to select the language.
(This manual assumes you chose the English language setting.)
To Next Page
Loading...
