3
1. Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a Tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its ange contacts the upper part of the holder and then tighten the screw
rmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or whenever the tool
is moving.
For details, see “Attaching a Tool” on
P.2-4
in CE6000-120AP User’s Manual.
The cutter holder is suitable only for use with the cutter plunger. Please refrain from attaching the plotting pen to it.
CAUTION
When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut your ngers.
Supplement
Please make certain to set the cutter plunger of the cutter holder (forward).
1 Loosen the tool holder screw.
Tool holder
Bracket to hold tool
Bracket to hold tool
Tool holder
Top
Supplement
Set the tool in the cutter holder (forward).
2 While pushing up the tool holder, push until its ange completely touches
the upper part of the holder.
FlangeBracket to hold tool
This cutter holder is
not set backward.
Cutter holder
(Forward)
Flange
Setting up the Plotter main unit
To Next Page
Loading...
