GRAPHTEC CE6000-120AP - Adjustment of Offset; Adjustment for Cutting out; Adjustment When Using Plotting Pen

13
CAUTION
When the [ENTER] key is pressed, the tool
carriage will start moving, so take care not to
cut your ngers.
5
Press the [ENTER] key.
1 cut test pattern is cut.
6
Press the [ENTER] key after completion.
CONDITION screen is displayed.
7
Press the [COND/TEST] key.
It will return to default screen.
Confirm the Results of the Cutting Test
Conrm the cutting test results, and adjust to optimal setting. Repeat cutting test and adjustment until optimal cut is achieved.
Adjustment of Offset
Check the corners of the triangles and rectangles. See "Setting the Tool Condition"
P.2-30
and adjust the offset value if the corner is not
cut or if it is cut too much.
Supplement
How to check offset
Check if the offset value is set correctly by following.
Not enough adjustment.
Increase the offset value.
Optimal offset value.
Too much adjustment.
Decrease the offset value.
Check the UP length when cutting.
When the UP length is not enough, those that are cut
during cutting, may come off.
Adjustment for Cutting Out
Adjustment for Cutting Out
Adjust so the media is completely cut out.
If the media is not completely cut, either the FORCE setting is too low or the cutter blade tip is not sufciently extended.
See "Adjusting the Blade Length"
P.11
and "Setting the Force"
P.2-35
and adjust the settings.
Adjustment When Using Plotting Pen
Adjust the FORCE so there will be no faint lines. To prolong the pen life, set the FORCE to the lowest setting without any faint lines. See
"Setting the Force"
P.2-35
or setting the FORCE.