Connecting the USB Cable
8 First, make sure that Windows 7 has been launched
successfully.
Next, connect the USB cable accompanying the CE6000-
120AP to your computer. Ensure that the CE6000-120AP
is turned off when you do.
(1) Ensure that the Plotter's power is turned off (" "
position).
(2) Connect the power cable.
(3) Connect the USB cable.
USB cable
1. Connect to your computer.
2. Connect to the Plotter.
9 Turn on the CE6000-120AP unit.
10 A message will appear momentarily on the bottom-right
of your Windows screen.
Click on this message.
11 The [Driver Software Installation] screen will appear.
Click on [Skip obtaining driver software from Windows
Update].
12 Click on [Yes] on the next screen.
13 The [Your Device is ready to use] screen will appear
momentarily.
Click on [Close].
This concludes the installation of the driver software.
To Next Page
Loading...
