GRAPHTEC CE6000-120AP - Page 15

15
A. Install CE6000-120AP Software
If you are using the CE6000-120AP for the rst time, click
on [Install CE6000-120AP Software] to install the device.
This operation will install the [CE6000-120AP Driver].
Note
Do not connect the accompanying USB cable
yet. Doing so may prevent the [Driver software]
from being installed properly.
Refer to the procedures in this User's Manual
when connecting the USB cable.
Installing the [CE6000-120AP Driver]
1 The [Setup] screen for the [Graphtec CE6000-120AP
Driver] will appear.
When it does, click on [OK].
2 Next, check to make sure the [CE6000-120AP] is not
connected to your computer, then click on [Next].
3 Click on [Next] again.
4 A window for selecting the [Port Name] to be used
appears.
Select [USB].
Clicking on [Next] will begin the driver software
installation process.
Available Port Names
USB : Selected when a USB cable is used for
connection.
COM1 : Selected when an RS-232C (serial) cable is
used for connection.
FILE : Selected to save outputted data (plot data) to
a le.
Supplement (When selecting the COM1)
To select "COM1" in "Selecting Port Name", do the
installation according to the message.
After the installation is completed, connect the RS-232C
cable. (
P.1-12
For more information about connecting
the RS-232C cable, see "1.4: Connecting to the Computer"
on page 1-6 in CE6000-120AP User's Manual.)
5 Continue with the installation process while following the
on-screen instructions.
6 The [Windows Security] screen will appear momentarily.
Click on [Install] to install the [Plotter Driver].
7 Next, the [Update for the Graphtec CE6000-120AP driver
was completed] screen will appear.
Click on [OK] to reboot your computer.
This concludes the installation of the [CE6000-120AP
Driver].
After rebooting your computer, follow the below procedures
to connect the USB cable.
Select "USB"